Mam problém s programem SimpleDyno https://sites.google.com/site/simpledyno/file-cabinet který ukladá ukládá a zobrazuje různé hodnoty, který mu posílá deska UNO z analogových i digitálních vstupů. Do desky nahraju sketch v pořádku. Ale program SimpleDyno se s deskou nespojí, napíše to chybu error reading com port. Zkoušeno na 8 různých PC a pouze na jednom to jde. Mam originál i replikovou desku, ale fungují jen na noteboku Asus, zbytek zkoušených PC se nepřipojí k desce. Je v PC něco co by bránilo kuminikaci COM portu mezi deskou a programem?
Děkuji
Kód: Vybrat vše
/*
Sketch for use with SimpleDyno
Developed on Arduino Uno Platform
DamoRC - 2013-2014
ALWAYS use the Sketch distributed with each new version of SimpleDyno
Transmits:
1 x Session timestamp
1 x Interrupt timestamp and 1 x time interval since last interrupt for INT0 / Pin2 / RPM1
1 x Interrupt timestamp and 1 x time interval since last interrupt for INT1 / Pin3 / RPM2
6 x Analog Inputs (A0 and A1 are Voltage and Current, A2 and A3 are Temperature, A4 and A5 are open)
Values are comma delimeted
Baud rates selected in SD must match coded values in this Sketch.
*/
const int NumPortsToRead = 6;
int AnalogResult[NumPortsToRead];
volatile unsigned long TimeStamp = 0;
volatile unsigned long time1 = 0;
volatile unsigned long time2 = 0;
volatile unsigned long Oldtime1 = 0;
volatile unsigned long Oldtime2 = 0;
volatile unsigned long TempTime1 = 0;
volatile unsigned long TempTime2 = 0;
String AllResult = "";
void setup() {
// Initialize serial communication
// Ensure that Baud rate specified here matches that selected in SimpleDyno
// Availailable Baud rates are:
// 9600, 14400, 19200, 28800, 38400, 57600, 115200
Serial.begin(9600);
// Initialize interupts (Pin2 is interrupt 0 = RPM1, Pin3 in interrupt 1 = RPM2)
attachInterrupt(0,channel1,FALLING);
attachInterrupt(1,channel2,FALLING);
}
void loop() {
AllResult = "";
AllResult += micros();
AllResult += ",";
AllResult += TempTime1;
AllResult += ",";
AllResult += time1;
AllResult += ",";
AllResult += TempTime2;
AllResult += ",";
AllResult += time2;
for (int Looper = 0; Looper < NumPortsToRead;Looper++){
AnalogResult[Looper] = analogRead(Looper);
AllResult += ",";
AllResult += AnalogResult[Looper];
}
Serial.println (AllResult);
Serial.flush();
delay(1);
}
//Interrupt routine for RPM1
void channel1(){
TempTime1 = micros();
time1 = TempTime1-Oldtime1;
Oldtime1 = TempTime1;
}
//Interrupt routine for RPM2
void channel2(){
TempTime2 = micros();
time2 = TempTime2-Oldtime2;
Oldtime2 = TempTime2;
}